 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| Dichromatic Leadless Chip LED Device LT1tt67A series LT1tt67A series s Outline Dimensions 1.60.15 0.8 3 4 2 1 Recommended PWB pattern for soldering 0.8 1616 Size, 0.8mm Thickness, Compact Dichromatic Leadless Chip LED Devices (Unit : mm) s Radiation Diagram (Ta=25C) -20 -40 0 100 Relative luminous intensity(%) +20 +40 1.60.15 80 60 40 20 +80 E.K +60 H.S.D -60 1.0 0.5 1.6 0.3 0.8 0.3 Soldering area 1.2 0.6 1.2 -80 X -20 -40 (0.4) (0.6) 1.Plating area Resist 2.Pin connections series KS Pin 1 Anode 4 Cathode Green 3 Cathode Sunset 2 Anode orange 0 100 Relative luminous intensity(%) +20 +40 80 60 40 20 H.S.D +60 E.K EH Yellow ED Yellow-green Yellow-green Red -60 3. Unspecified tolerance:0.1 -80 +80 Y s Absolute Maximum Ratings *1 (Ta=25C) Power dissipation Forward current Peak forward current P IF IFM*2 (mW) (mA) (mA) Derating factor Reverse voltage Operating temperature Storage temperature Soldering temperature (mA/C) VR Topr Tstg Tsol*3 (V) (C) (C) (C) DC Pulse 350 350 350 350 350 350 Model No. Radiation color Radiation material -30 to +85 -40 to +100 5 0.40 0.67 50 30 84 Yellow-green GaP 5 0.40 0.67 50 30 -30 to +85 -40 to +100 84 GaAsP on GaP Yellow -30 to +85 -40 to +100 Green 5 0.40 0.67 50 30 84 GaP LT1KS67A -30 to +85 -40 to +100 Sunset orange GaAsP on GaP 5 0.40 0.67 50 30 84 -30 to +85 -40 to +100 5 Yellow-green GaP 0.40 0.67 50 30 84 LT1ED67A -30 to +85 -40 to +100 5 0.40 0.67 50 30 84 GaAsP on GaP Red *1 The value is specified under the condition that either color is lightened separately. When the both diodes are lightened simultaneously, the power dissipation of each diode should be less than the half of the value specified in this table. *2 Duty ratio=1/10, Pulse width=0.1ms *3 For 3s or less at the temperature of hand soldering. Temperature of reflow soldering is shown on the below page. LT1EH67A s Electro-optical Characteristics Radiation Lens Model No. color type Yellow-green LT1EH67A Yellow Milky Green diffusion LT1KS67A Sunset orange Yellow-green LT1ED67A Red Forward voltage VF(V) TYP 2.1 2.0 2.1 2.0 2.1 2.0 MAX 2.8 2.8 2.8 2.8 2.8 2.8 Peak emission wavelength IF p(nm) (mA) TYP 20 565 20 585 20 555 20 610 20 565 20 635 Luminous intensity IF IV(mcd) (mA) TYP 20 19.0 20 8.3 20 3.8 20 6.9 20 19.0 20 8.8 Spectrum radiation bandwidth IF (nm) (mA) TYP 20 30 20 30 20 25 20 35 20 30 20 35 Reverse current VR IR(A) (V) MAX 4 10 4 10 4 10 4 10 4 10 4 10 Terminal capacitance Ct(pF) TYP 35 35 40 15 35 20 (Ta=25C) Page for characteristics (MHZ) diagrams 1 1 1 1 1 1 devices catalogs, data books, etc. Contact SHARP 2 (Internet) Data forshown inoptoelectronic/power device is provided for in order to obtain the latest device specification sheets before using any SHARP device. sharp's internet.(Address http://www.sharp.co.jp/ecg/) (Notice) In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP LED Lamp EG series Characteristics Diagrams Forward Current Derating Curve 60 Forward Current vs. Forward Voltage(Note) 100 50 (Ta=25C) Luminous Intensity vs. Ambient Temperature(Note) 1000 500 (Ta=25C) 50 Relative luminous intensity(%) 1.2 1.4 1.6 1.8 2.0 2.2 2.4 2.6 Forward current IF(mA) Forward current IF(mA) 40 10 5.0 100 50 30 20 1.0 0.5 10 5.0 10 0 -25 0 25 50 75 85 100 125 0.1 1.0 1.0 -20 0 20 40 60 80 100 120 Forward voltage VF(V) Ambient temperature Ta(C) Ambient temperature Ta(C) Peak Forward Current Derating Curve 60 Luminous Intensity vs. Forward Current(Note) 1000 500 (Ta=25C) Duty Ratio vs. Peak Forward Current (Ta=25C) 500 200 Peak forward current IFM(mA) 100 50 50 Relative luminous intensity(%) 200 100 50 Peak forward current IFM(mA) 40 30 20 10 5.0 2.0 20 10 5.0 2.0 1.0 20 10 0 -25 0 25 50 75 85 100 125 1.0 0.1 0.2 0.5 1 2 5 10 20 50 1/50 1/20 1/10 1/5 1/2 1 Ambient temperature Ta(C) Forward current IF(mA) Duty ratio DR KG series Forward Current Derating Curve 60 Forward Current vs. Forward Voltage(Note) 100 50 (Ta=25C) Luminous Intensity vs. Ambient Temperature(Note) 1000 500 (Ta=25C) 50 Relative luminous intensity(%) 1.2 1.4 1.6 1.8 2.0 2.2 2.4 2.6 Forward current IF(mA) Forward current IF(mA) 40 10 5.0 100 50 30 20 1.0 0.5 10 5.0 10 0 -25 0 25 50 75 85 100 125 0.1 1.0 1.0 -20 0 20 40 60 80 100 120 Forward voltage VF(V) Ambient temperature Ta(C) Ambient temperature Ta(C) Peak Forward Current Derating Curve 60 Luminous Intensity vs. Forward Current(Note) 1000 500 (Ta=25C) Duty Ratio vs. Peak Forward Current (Ta=25C) 500 200 Peak forward current IFM(mA) 100 50 50 Relative luminous intensity(%) Peak forward current IFM(mA) 200 100 50 40 30 20 10 5.0 2.0 20 10 5.0 2.0 1.0 20 10 0 -25 0 25 50 75 85 100 125 1.0 0.1 0.2 0.5 1 2 5 10 20 50 1/50 1/20 1/10 1/5 1/2 1 Ambient temperature Ta(C) Forward current IF(mA) Duty ratio DR Note)Characteristics shown in diagrams are typical values. (not assurance value) devices catalogs, data books, etc. Contact SHARP 0 (Internet) Data forshown inoptoelectronic/power device is provided for in order to obtain the latest device specification sheets before using any SHARP device. sharp's internet.(Address http://www.sharp.co.jp/ecg/) (Notice) In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP LED Lamp HS series Characteristics Diagrams Forward Current Derating Curve 60 Forward Current vs. Forward Voltage(Note) 100 50 (Ta=25C) Luminous Intensity vs. Ambient Temperature(Note) 1000 500 Relative luminous intensity(%) (IF=20mA) 50 Forward current IF(mA) 40 Forward current IF(mA) 20 10 5 3 2 200 30 100 50 20 10 1 0 -25 0.5 1.0 20 10 1.2 1.4 1.6 1.8 2.0 2.2 2.4 -20 0 20 40 60 80 100 Forward voltage VF(V) Ambient temperature Ta(C) 0 25 50 75 85 100 125 Ambient temperature Ta(C) Peak Forward Current Derating Curve 60 Luminous Intensity vs. Forward Current(Note) 500 (Ta=25C) Duty Ratio vs. Peak Forward Current 500 300 (Ta=25C) 50 Relative luminous intensity(%) Peak forward current IFM(mA) 200 Peak forward current IF(mA) 100 50 40 100 50 30 30 20 10 5 20 10 2 0 -25 0 25 50 75 85 100 125 1 0.1 0.2 0.5 1 2 5 10 20 50 10 5 1/50 1/20 1/10 1/5 1/2 1 Forward current IF(mA) Duty ratio DR Ambient temperature Ta(C) HY series Forward Current Derating Curve 60 Forward Current vs. Forward Voltage(Note) 100 50 (Ta=25C) Luminous Intensity vs. Ambient Temperature(Note) 1000 500 (Ta=25C) 50 Relative luminous intensity(%) 1.2 1.4 1.6 1.8 2.0 2.2 2.4 2.6 Forward current IF(mA) 40 Forward current IF(mA) 10 5.0 100 50 30 20 1.0 0.5 10 5.0 10 0 -25 0 25 50 75 85 100 125 0.1 1.0 1.0 -20 0 20 40 60 80 100 120 Forward voltage VF(V) Ambient temperature Ta(C) Ambient temperature Ta(C) Peak Forward Current Derating Curve 60 Luminous Intensity vs. Forward Current(Note) 1000 500 (Ta=25C) Duty Ratio vs. Peak Forward Current (Ta=25C) 500 200 Peak forward current IFM(mA) 100 50 50 Relative luminous intensity(%) 200 100 50 Peak forward current IFM(mA) 40 30 20 10 5.0 2.0 20 10 5.0 2.0 1.0 20 10 0 -25 0 25 50 75 85 100 125 1.0 0.1 0.2 0.5 1 2 5 10 20 50 1/50 1/20 1/10 1/5 1/2 1 Ambient temperature Ta(C) Forward current IF(mA) Duty ratio DR Note)Characteristics shown in diagrams are typical values. (not assurance value) In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device. (Internet) Data for sharp's optoelectronic/power device is provided for internet.(Address http://www.sharp.co.jp/ecg/) (Notice) 11 HD series Forward Current Derating Curve 60 Forward Current vs. Forward Voltage(Note) 100 50 (Ta=25C) Luminous Intensity vs. Ambient Temperature(Note) 1000 500 (Ta=25C) 50 Relative luminous intensity(%) 1.2 1.4 1.6 1.8 2.0 2.2 2.4 2.6 Forward current IF(mA) Forward current IF(mA) 40 10 5.0 100 50 30 20 1.0 0.5 10 5.0 10 0 -25 0 25 50 75 85 100 125 0.1 1.0 1.0 -20 0 20 40 60 80 100 120 Forward voltage VF(V) Ambient temperature Ta(C) Ambient temperature Ta(C) Peak Forward Current Derating Curve 60 Luminous Intensity vs. Forward Current(Note) 1000 500 (Ta=25C) Duty Ratio vs. Peak Forward Current (Ta=25C) 500 200 Peak forward current IFM(mA) 100 50 50 Relative luminous intensity(%) 200 100 50 Peak forward current IFM(mA) 40 30 20 10 5.0 2.0 20 10 5.0 2.0 1.0 20 10 0 -25 0 25 50 75 85 100 125 1.0 0.1 0.2 0.5 1 2 5 10 20 50 1/50 1/20 1/10 1/5 1/2 1 Ambient temperature Ta(C) Forward current IF(mA) Duty ratio DR Note)Characteristics shown in diagrams are typical values. (not assurance value) |
Price & Availability of LT1EH67A
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |